No products
Prices are tax included
New product
The 22mm diameter of Spirals tank is compatible with most mods. The built-in large size coil head uses Japanese imported cotton, this tank has small to medium air intake holes and is an ideal mouth to lung tank.
2 Items
In Stock
Warning: Last items in stock!
By buying this product you can collect up to 22 loyalty points. Your cart will total 22 loyalty points that can be converted into a voucher of £ 1.10.
The 22mm diameter of Spirals tank is compatible with most mods. The built-in large size coil head uses Japanese imported cotton, this tank has small to medium air intake holes and is an ideal mouth to lung tank.
Available in a variety of colours and 2ml in capacity.
There are 6 colors for you, and any one of them can compatible with all mods.
Spirals Tank/Spirals Plus Tank has 4 small air slots on the bottom, airflow can be adjusted freely, which allows you to have an extremely open draw.
The delrin drip tip will bring increased airflow and provide you with powerful draw effects.
Top refill system makes filling as easy as it gets.
1 . Before starting, make sure your hands are clean.
2. Take RBA deck apart.
3. Install and position the pre-wrapped coil. Place the coil between the posts and wrap the ends around the screws and tighten up, once all is in place, make sure the coil is fixed in the center and lined up with the air hole, and also make sure the coil is NOT touching the base.
4. Cut the excess ends of the wire off.
5. Cut a strip of cotton and make sure it’s not too much and not too little.
6. Insert the cotton and placing it in the middle of the coil.
7. Cut the cotton at an angle and make sure it’s not too short and not too long.
8. Wet the coil with your e-liquid and adjust the cotton.
Warning: Coils must be checked for resistance before they are fired on a device, and re-checked periodically to ensure the resistance remains the same.